email

 

#SEA50 Series Battery Over Charge Regulators

The World's lowest priced 50 amp battery regulator!

Used to prevent battery over charging on / Wind - Solar - Hydro

A battery regulator diverts any excess power into some other useful device when ever your battery is full.

Use the this excess power to make free hot water or to recharge an auxiliary battery bank, so many uses!

Do voltage regulation the right way -

Divert the load and keep the power coming!

Regulate your BATTERY instead of your wind turbine, solar panels or your other AE devices.

"Why you I need a DUMP (diversion load) type device for all wind power applications?"

A PMA emits a pulsing type DC current that can throw out billions of charged ions.

In an enclosed box like a voltage regulator or a fuse. This effect can produce long sparks that

resemble "lightning bolts" that can and will burn out most circuits even solid state types rated to 1000 volts.

For this reason you need to regulate ONLY your BATTERY and NOT your wind turbines input power wires.

 

Versatile! Regulates all 12, 24, or 48 volt sectional battery banks (Built for battery bank build out of smaller sections)

Requires only 12 volts to give the "SEA50" a representative reading of your whole battery bank no matter how large it is!

  • · Battery regulator.
  • · Charge regulator.
  • · Charge controller.
  • · Dump load regulator.
  • · Diversion load regulator.
  • · Includes 50 amp automatic self-resetting fuse.
  • · Works for all Wind Turbines, Solar and Hydro.
  • · For all voltages ranges in multiple battery banks.
  • · No transistors or mosfets - Lighting strike proof isolation.
  • · Draws ZERO electrical current when sensing! 100% electrically efficient!
  • The #SEA-50 is an extremely robust battery voltage regulator!

    • No fancy lights, meters, bells or whistles. Nothing to break!!!

    Just a simple, tough voltage regulator encased in water proof plastic.

    Works on any voltage battery bank build in sections.

    "A BULLET PROOF SYSTEM"

    Our wind turbines produce unregulated D.C. voltage and may require a charge controller for non-grid connected applications. Batteries can take higher charging voltages during charge up but once they are full any additional charging power must be diverted away.

    The modern way to monitor your battery from over charging is to have a diversion load that performs another task such as heating water when your battery is in danger of over charging. Shutting down the output of your wind turbine or your other renewable energy devices is old school thinking. Now-a-days most people dump their excess power into some other legitimate device optimizing their energy independence.

    Our wind turbines do not have charge controllers inside the PMA. Our philosophy is to keep all the electronics easily accessible at ground level and as close to the battery or grid feeder as possible. Raising and lowering turbines is not a fun job so you'll want to put as few components as possible on the top of your tower. Having a charge controller 40 feet in the air is very inconvenient to adjust, monitor and service to say the least!

    Do it the right way and use the load diverting "DUMP LOAD" philosophy!

    Regulate your BATTERY instead of your AE device

    A battery regulator does NOT regulate wind turbines, solar panels, hydro power or any other energy producing device. The SEA50 only regulates the BATTERY from over charging powering a 'diversion'

     

     

     

    [Home] [Hornets] [blades] [Blade Theory] [warning] [Fitting] [projects] [Turbine Kit] [power/charts] [Battery-tales] [Hub-Bub] [Dump-load] [relay] [USA Hornet] [440amp relay] [Manta-PMA]