email

 

Warnings;

PMA's are very polarity sensitive. Make sure you connect positive to positive when making your final battery connection!!! If you see sparks coming from the connector at the time of electrical hook up you may have the positive lead going to negative side of the battery. This may cause fires and burn out the coils in your PMA immediately.

Please note that these blades are very sharp and can cause severe injury if handled improperly. Treat these blades with the same respect you would have for a sharp sword.

These blade sets can turn at well over 2000 RPM on a windy day and can cause severe bodily injury when they are spinning. Use extreme caution! Never mount or work on a wind turbine on a windy day. Never place a turbine in any area that can be accessed by inexperienced persons or children. We assume no liability for ANY injuries caused by these products.

NOTE: WIND TURBINES SHOULD BE LOWERED BEFORE ANY MAJOR STORMS JUST AS GOOD PRACTICE!

KEEP UNUSED TURBINES UNDER ELECTRIC LOAD. (Short out wires when turbine is stopped, to prevent free spinning Never stop a turbine in high wind, or when spinning,or you will burn out,

if in doubt ask me first, I am a exspert and will answer all questions.

(SHORT OUT THE POWER WIRES WHEN NOT IN USE OR IN THE CASE OF EMERGENCY LOWERING)

 

The Hornet turbine has no furling or other protection device for high wind speeds.

When the wind is galing you should be making power and not hiding.

We are one of the few companies that offer high speed power ratings!

This turbine is designed to take full advantage of punishing wind conditions.

Blades are rated to: 136 MPH / TESTED

(Note: 99.9% of all catastrophic wind turbine failures occur when

the tower fails and not the turbine itself. Build your towers tough!)

 

[Home] [Hornets] [blades] [Blade Theory] [warning] [Fitting] [projects] [Turbine Kit] [power/charts] [Battery-tales] [Hub-Bub] [Dump-load] [440amp relay] [Manta-PMA]